105020 Cramaro (OEM) Rear Cable Pulley 4"

105020 Cramaro (OEM) Rear Cable Pulley 4"

Starting on one side of the bed, thread the 1/4" cable around the top of the front pulley and through each bow end, stopping just after the last bow. Take the other end of the cable from under the front pulley and wrap it around the rear pulley, and then go over last bow block. Temporarily clamp each side of the last bow with vise grip pliers.. Make sure the rear pulleys are in the forward position to allow for later adjustment. Pull the cable as tight as possible and fasten securely with two cable clamps. Make sure to place the cable clamps as shown. Release the vise grip pliers and cut off the excess cable approximately 2" past the cable clamps.
Repeat for the other side. The last bow must be the same distance from the front pulley on each side.
Loosen the rear pulley nut 1/2 turn. Tighten the spanner adjustment nut until there is enough tension to where 18" forward of the rear bracket, the cables can be squeezed by hand to within 1". DO NOT over tighten the cable damage will occur to the front assembly.

The cable tension is correct when you cannot easily touch the cable together when squeezing with one hand 18" from the rear pulley. It is recommended to check tension after 2 weeks of the initial install.

The cable is adjusted by first loosening the main nut on the rear pulley using a 1 1/8" wrench and then tightening the cable by using a 3/4" wrench on the rear spanner nut. Be sure to retighten the pulley nut.

Please feel free to Contact Us with any Questions. Thank You!